HPE StoreOnce Performance

[MLThr8]

Hi all,

Just wondered if anybody on here had some real world performance figures of what there getting backing up from a VMWare 6.5/6.7 enviroment on a HPE 3PAR to a HPE Storeonce 5100?

Just curious as to if ours is running as expected or if there is an issue in the environment somewhere. Backups seem to be taking us quite a while to complete.

Many Thanks

[foggy]

Hi Michael, what numbers do you see? What is reported as the primary bottleneck for your jobs?

Please review the following threads, should give you something to think about:
StoreOnce Catalyst performance not as expected
Real world restore speeds using HPE StoreOnce 3540

Thanks!

[MLThr8]

Currently all our jobs seem to be averaging a processing rate of between 50-60MB/s. Sometimes this can Peak up to between 70-80.

Currently have a job running at 56MB/s Bottleneck is the target but bottleneck figures are currently: Source: 13%, Proxy: 6%, Network 12%, Target 48%.

Does this sound reasonable or a bit on the slow side?

Thanks

[foggy]

Depending on the setup it might be faster. Make sure everything is according to recommendations and check settings discussed in the threads mentioned above.

[MLThr8]

Depending on the setup it might be faster.

Does that mean it sounds as if it's under performing to you then? What would you expect these numbers to be around?

[foggy]

Looking at the numbers in the referred thread, it could be closer to 150MB/s.