Comprehensive data protection for all workloads
Post Reply
ian0x0r
Veeam Vanguard
Posts: 235
Liked: 48 times
Joined: Nov 11, 2010 11:53 am
Full Name: Ian Sanderson
Location: UK
Contact:

Potential bug with replica seeding

Post by ian0x0r »

Sorry if this has been covered before, but the issue I have is as follows.

Enable low connection bandwidth on replication job to allow for replica seeding. Seed the job with a pre-existing replica and the job runs as expected.
However, if for whatever reason the replica VM is then deleted, and you simply untick the low connection bandwidth option, the job still tries to find the replica seed and fails. If you leave the low connection bandwidth option ticked, and then manually remove the seed this way, the job runs fine. I just would have expected the job to stop looking for a seed if the low connection bandwidth option was unticked.

Perhaps there is a reason for this behaviour, its just not what I was expecting. This is with Veeam B&R 6.1 patch 1a

Thanks,

Ian :mrgreen:
Check out my blog at www.snurf.co.uk :D
foggy
Veeam Software
Posts: 21069
Liked: 2115 times
Joined: Jul 11, 2011 10:22 am
Full Name: Alexander Fogelson
Contact:

Re: Potential bug with replica seeding

Post by foggy »

Ian, this is a known behavior already addressed in 6.5. Thanks!
ian0x0r
Veeam Vanguard
Posts: 235
Liked: 48 times
Joined: Nov 11, 2010 11:53 am
Full Name: Ian Sanderson
Location: UK
Contact:

Re: Potential bug with replica seeding

Post by ian0x0r »

Ah great thanks for the quick reply.
Check out my blog at www.snurf.co.uk :D
Post Reply

Who is online

Users browsing this forum: No registered users and 220 guests