Comprehensive data protection for all workloads
Post Reply
PedroVDP
Service Provider
Posts: 19
Liked: 2 times
Joined: Jan 18, 2012 9:10 am
Contact:

Synthetic fulls - Transform not happening

Post by PedroVDP »

Hi,

I have a backup job configured to start at 1800h. However this is a job that contains quite a number of systems and the backup itself runs until past midnight. When I was reviewing the log for the job it mentioned the below:

Code: Select all

[11.11.2012 00:49:13] <01> Info     [Transform] Checking the need of transformation...
[11.11.2012 00:49:15] <01> Info     [Transform] Transformation is not needed.
I have 'Sunday' selected as my transform day and that is when the job started... but is it possible that because it ran until the Monday it is not detected as such?
foggy
Veeam Software
Posts: 21069
Liked: 2115 times
Joined: Jul 11, 2011 10:22 am
Full Name: Alexander Fogelson
Contact:

Re: Synthetic fulls - Transform not happening

Post by foggy »

Transform should start if it is set to run at the day when the job is started (job start time does matter here).

However, from the log I can see that the check for transform is performed on 11.11.2012 at 00:49:13, so possibly this is the Saturday's job run (not Sunday's, as you have specified) and transform should not start this time?
PedroVDP
Service Provider
Posts: 19
Liked: 2 times
Joined: Jan 18, 2012 9:10 am
Contact:

Re: Synthetic fulls - Transform not happening

Post by PedroVDP »

You know... you're 100% right
Post Reply

Who is online

Users browsing this forum: No registered users and 206 guests