Can Windows based Veeam v13 config backup be restored to v13 software appliance?

[mjm599]

Hi All,

We had a VMware VM with windows 2022 installed on it and then Veeam v13 installed on that as the B&R Server.

The storage has failed and we have lost the above VM.

We have a Veeam config backup.

Could we deploy a new Veeam v13 Software Appliance (Rocky Linux) then once deployed restore the above config file that was created in the windows veeam vm?

Or do we need to deploy windows server again then install veeam v13 then restore the config?

Thanks,

[Mildur]

Hi Mjm599,

Yes, but please note that this is not a typical configuration restore and will not work out of the box.

If you plan to migrate or restore from a Windows-based Veeam Backup & Replication server to the Veeam Software Appliance, please follow the process documented in KB4800: https://www.veeam.com/kb4800
Another important source of information is the VSA Conversion Portal: https://go.veeam.com/vsa-conversion

The Windows-based source backup server must have been on the latest supported 13.0.x patch level before performing this migration. Older v13 builds are not recommended due to known migration-related issues. And you need to open a support case to request a migration key for your product license.

If your Windows-based backup server was already been upgraded to v13.1, then a configuration restore or migration to the Veeam Software Appliance is currently not possible. In that case, you would need to restore the configuration to a Windows-based backup server and wait for a future release where the migration path becomes available again.

Please review both resources I shared carefully before starting, as the migration has specific prerequisites, limitations, and post-migration considerations.

Best,
Fabian