Discussions specific to the Microsoft Hyper-V hypervisor
Post Reply
lucatabo
Lurker
Posts: 1
Liked: never
Joined: Dec 28, 2017 5:54 pm
Full Name: LucaTabo
Contact:

Backup on RDX - Only the last restore point available

Post by lucatabo » Jan 11, 2018 2:06 pm

Good morning all.
We are using Veeam B&R 9.5 to backup a single hyper-v host, which contains two virtual machines.
We are backing it up using a tandberg usb 3.0 RDX drive. We have 12 cartdriges, 6 per week.
I have enabled the option "This repository is backed by rotated hard drives" in the repository.
The number of restore point to keep on disk is set to 14.
The Backup mode is set to Incremental (but also with reverse incremental i have the same problem).
We create an active full backup on the first monday of the month.

When i try to perform a restore, i only see the restore point LESS THAN A DAY AGO, so only the last backup made.

I've spoke with the support team and they told me that I have to IMPORT the backup from the cartdrige before try to perform a restore.
I've tested this behavoir and it works, so now I am sure that i can restore backups from all the cartdriges.

My question is: can you please add a feature to avoid to import the backups from the cartdriges, and make the restore point available directly from the restore wizard?

Thanks and regards
Luca
Tabo

foggy
Veeam Software
Posts: 16691
Liked: 1343 times
Joined: Jul 11, 2011 10:22 am
Full Name: Alexander Fogelson
Contact:

Re: Backup on RDX - Only the last restore point available

Post by foggy » Jan 22, 2018 4:06 pm

Hi Luca, with rotated drives scenario, you should see all the restore points currently stored on the drive that was the last one the job was backing up to. If your cartridge contains just a single restore point, the behavior you're seeing is expected. Thanks for the feature request though.

Post Reply

Who is online

Users browsing this forum: No registered users and 7 guests