Comprehensive data protection for all workloads
Post Reply
jcn.of@taarnby.dk
Lurker
Posts: 2
Liked: never
Joined: Feb 26, 2018 8:08 am
Full Name: Jens Nielsen
Contact:

Merging and allowed data transfer times

Post by jcn.of@taarnby.dk » Feb 26, 2018 8:24 am

Hi there
My backup copy jobs end up with a merge to create a new restore point. This is all good.
My question is if the merge-process will continue even though it runs past the time I have specified in the "This job can transfer data" setup for the backup copy job.
Lets say that the backup copy job is not allowed to transfer data after 9 AM but the merge process won't finish until 11 AM.
Will the merge process complete or be terminated?
Regards Jens

DGrinev
Veeam Software
Posts: 1743
Liked: 221 times
Joined: Dec 01, 2016 3:49 pm
Full Name: Dmitry Grinev
Location: St.Petersburg
Contact:

Re: Merging and allowed data transfer times

Post by DGrinev » Feb 26, 2018 11:09 am

Hi Jens and welcome to the community!

If I get you right by merge-process you mean injecting data blocks of increment into a full backup file, the process should be completed in the scenario you've described.
The merge process is performed on the target side without transferring data. Thanks!

jcn.of@taarnby.dk
Lurker
Posts: 2
Liked: never
Joined: Feb 26, 2018 8:08 am
Full Name: Jens Nielsen
Contact:

Re: Merging and allowed data transfer times

Post by jcn.of@taarnby.dk » Feb 26, 2018 12:19 pm

Hi Dmitry

Thank you.
Ok. I will give it a try. I was afraid to mess up my backup copy job.
Regards Jens

Post Reply

Who is online

Users browsing this forum: No registered users and 49 guests